Armourflex Door Oil SDS 
Armourflex Door Oil
5* STAR PERFORMANCE
5* STAR PERFORMANCE
Swipe to view other images
Armourflex Door Oil
Product description:
Barrettine's, Armourflex Door Oil is expertly designed for interior wooden doors and wood panels, offering superior nourishment and protection. It delivers a high quality matt or satin finish that effectively resists handling marks, stains, and scratches from everyday use with the benefit of being certified Food & Toy safe. Suitable for all types of solid wood and premium veneers, it naturally enhances the wood’s rich tones, ensuring long-lasting protection from warping and splitting without peeling or flaking.
- Stain, Dirt & High Scratch Resistance
- Natural Oil / Waxed Based
- Certified Food & Toy Safe
- 4 Hour Drying Time
- Manufactured in the UK
Size: 1 Litre
FINISHES:
For freshly laid wood, allow to acclimatise in the room for several days before treating. Moisture content should be below 15%. Previous coatings must be fully sanded back before application. Resinous deposits should be removed with a scraper and the surface degreased, with methylated spirits. Repair cracks or open joints with a suitable wood filler. Use 120-150 grit sandpaper to achieve a smooth surface on the wood. Remove any sanding dust thoroughly before application. If required, apply wood dye.
IMPORTANT! Test the colour and compatibility with any wood fillers or dyes on a scrap piece of wood before use.
Application top tips
- Read full label instructions and stir tin well before application.
- Apply sparingly. Do not over apply.
- Tight-grain hardwoods require less product to achieve final finish.
- Stated drying times are based on average climatic conditions.
- Apply in the direction of the wood grain.
- If a second coat is required key surface with light sand paper.
- Apply the second coat sparingly and wipe off any excess that’s not absorbed.
Carry out a test patch before starting any project.
Ensure good ventilation is maintained during application and throughout the drying process. Ready to use, do not thin.
Stir thoroughly before use. Apply in thin coats using a short pile roller, good quality brush or lint-free cloth. Over-application can reduce the finish quality and prolong drying time. On previously treated timber 1 coat is normally sufficient, maximum of 2 coats may be required if applying to fresh or previously untreated timber.
Coverage: Approximately 24-28 m2/l (One Coat), 12-16 m2/l (two coats), depending on substrate absorbency and smoothness.
Drying Time: 4 hours under average climatic conditions (23oC, 50% humidity). Preferably allow to dry overnight. Variations in ambient conditions and substrate can affect drying times.
Equipment Cleaning: Clean brushes/rollers with Barrettine White Spirit immediately after use. If spilled, wipe off immediately with a cloth dampened with Barrettine White Spirit.
Precaution: Cloths used for oiling could, under certain conditions, self-combust. Immediately after use, soak them in soapy water then lay them flat outside on a non-combustible surface to dry.
Marks and scratches can be touched up without the requirement for sanding. Ensure areas to be repaired are clean and dry. To renovate large areas lightly sand with 120-150 grit sandpaper, remove dust and then apply a single, thin coat. ArmourFlex® Door Oil imparts a tough, resilient surface to the wood that resists typical daily wear and tear. To help retain the best appearance a good level of general care is advised. Clean surfaces with a none abrasive pH balanced cleaner such as Armourflex Wood Surface Cleaner and avoid scouring with abrasive creams or sponges.
Storage advice: Store upright and in a cool frost-free area between 5-30°C.
